|
|
|
Push To Open Systems
Push To Open Systems
https://www.fit-nz.co.nz/core/media/media.nl?id=188459&c=4148197&h=wtbmTjZVT3rP3s0HNNG1nAkqcy1gV3igCDGUyzBjIGRdYe36
Designed for handleless doors, giving a modern streamlined look to cabinetry, Duras K-Line Push-to-Open systems are a quality European product available in both clip on and drill in options. Also designed for handleless doors, Salice push systems are conceived of and manufactured in Italy and are available in both mechanical and magnetic options. Use with Salice push hinges.
DURAS K-Push Push To Open System
DURAS K-Push Push To Open System
K-PUSH Quality European push to open door system for handleless doors
Works well with standard sprung hinges
Available with 14mm throw (DKP103)
Drill into carcass edge
3mm adjustment
Requires minimum gap of only 2.6mm 100 in a pack. Orderable by singles. Priced per each. To convert to a clip on unit, simply order the corresponding adaptor housing:
For 14mm throw unit (DKP103), order housing DKP101
Adaptor housings with minimum gap of 1.8mm K PUSH TECH K Push Tech: patent pending quality Italian push to open system for handleless doors
Suitable for a wide range of doors
Available with buffer for cabinets using sprung hinges
Available with magnet for cabinets using unsprung hinges or negative hinges
Same unit can be installed concealed or visible, fixed with adaptor housing
Adaptor housing allows pre-installation before transportation; simply leave ejector pin deactivated during handling and transport
Available in anthracite and white finishes
Reduced gap between door and cabinet – activation gap now just 1.4mm, ring thickness now just 0.6mm
Increased adjustment: +6 / –0.45mm (beyond this negative adjustment, the spring is deactivated). This feature allows disabling of ejector pin for safety purposes  |
Salice Push to Open System - Magnetic
Salice Push to Open System - Magnetic
Magnetic push-to-open system for handleless doors
Designed and manufactured in Italy Release device (SAL267) is recessed in a 10mm x 40mm hole in top, side or base of cabinet
Select either SAL268 retaining catch or SAL269 adjustable magnetic retaining catch
Select one of two adjustable screw on plastic adaptors if required: SAL270 for 8x16mm drilling or SAL271 for 37x32mm drilling Note: Position release device on point of pressure of door |
Salice Push to Open System - Mechanical
Salice Push to Open System - Mechanical
Adjustable self-opening mechanical push system for handleless doors
Designed and manufactured in Italy Release device (SAL241 or SAL242) can be fitted to top, base or side panel of cabinet
Retaining catch (SAL243 or SAL244) can be fitted to back of cabinet door by pressure fixing or screw fixing
For doors over 1600mm wide, recommend using two mechanical release catches
These systems operate with Salice reverse sprung hinges. RELEASING DEVICES
SAL241 has an assembly stop device
SAL242 has depth adjustment facility with range of -1mm to +2.5mm, controlled by small adjustor wheel at back of adaptor and a sideways adjustment of ±2mm achieved by loosening fixing screws and adjusting adaptor position then retightening screws. RETAINING CATCHES
SAL243 for wood doors, knock in type
SAL244 for wood doors, screw on type Items are priced per each |
|
|
|
|
|
