|
Push To Open Systems
http://www.fit-nz.co.nz/core/media/media.nl?id=188459&c=4148197&h=36b32ccf7729e6b9ec26
Designed for handleless doors, giving a modern streamlined look to cabinetry, Duras K-Line Push-to-Open systems are a quality European product available in both clip on and drill in options. Also designed for handleless doors, Salice push systems are conceived of and manufactured in Italy and are available in both mechanical and magnetic options. Use with Salice push hinges.
DURAS K-Push Push To Open System
Quality European push to open door system for handleless doors Works well with standard sprung hinges Available with 14mm throw (DKP103) or 41mm throw (DKP104) Drill into carcass edge 3mm adjustment Requires minimum gap of only 2.6mm To convert to a clip on unit, simply order the corresponding adaptor housing: For 14mm throw unit (DKP103), order housing DKP101 For 41mm throw unit (DKP104), order housing DKP102 Adaptor housings with minimum gap of 1.8mm
|
Salice Push to Open System - Magnetic
Magnetic push-to-open system for handleless doors Designed and manufactured in Italy Release device (SAL267) is recessed in a 10mm x 40mm hole in top, side or base of cabinet Select either SAL268 retaining catch or SAL269 adjustable magnetic retaining catch Select one of two adjustable screw on plastic adaptors if required: SAL270 for 8x16mm drilling or SAL271 for 37x32mm drilling Note: Position release device on point of pressure of door
|
Salice Push to Open System - Mechanical
Adjustable self-opening mechanical push system for handleless doors Designed and manufactured in Italy Release device (SAL241 or SAL242) can be fitted to top, base or side panel of cabinet Retaining catch (SAL243 or SAL244) can be fitted to back of cabinet door by pressure fixing or screw fixing For doors over 1600mm wide, recommend using two mechanical release catches These systems operate with Salice reverse sprung hinges. RELEASING DEVICES SAL241 has an assembly stop device SAL242 has depth adjustment facility with range of -1mm to +2.5mm, controlled by small adjustor wheel at back of adaptor and a sideways adjustment of ±2mm achieved by loosening fixing screws and adjusting adaptor position then retightening screws. RETAINING CATCHES SAL243 for wood doors, knock in type SAL244 for wood doors, screw on type
|
|
|
|
|
|