Designed in Italy to comply with Australian/New Zealand standards Developed with an innovative diffusing silicone material extrusion technology, this LED strip was specifically conceived for recessed installation and is ideal for use in wardrobes, pantry cupboards and many other situations. Exceeds international safety requirements for temperature generation limits for recessed application
Side emitting 'No dot technology' for homogenous, no visible dot light emission Super flexible for tight corners or creative lighting designs Recessed installation in 4mm wide / 10mm deep milled grooves 7mm diameter hole required for plug connector to exit No tape or tools required; simply press into your pre-milled groove Minimum radius of just 15mm
Comes with 150mm power supply cable and 2m extension cord included and is equipped with a Micro12 connector Maximum suggested length of 3m in a run Customisable lengths - SE H4 strip may be cut in 25mm increments Should you trim the SE H4 strip, a cap is provided for insertion into cut end SE H4 is very flexible and is suitable for tight corners, however not a 90° corner 120 LED/m LED strip only IP44 rated; protected against solid foreign objects greater than 1mm and splashes of water from any direction
Available in Natural White and Warm White light colours Available in 1m, 2m and 3m lengths 3m lengths also available with double power cables
Extension cords available in 1m and 2m lengths to extend distance between LED driver distibution block and LED strip. Keep to a minimum and do not exceed 6m total length. Don't forget! Order LED distributor block and LED drivers separately
For 1m SEH4 strip order 15W driver per length, for 2m & 3m SEH4 strips order a 30W driver per length. If running more than 3m on one driver, order a 75W but do not exceed 6m in total.
