Flexible LED Strip

Domus Line 24Vdc AT6 Pro D-Motion Dual Colour High Emission LED Strip

What does D-Motion Dual Colour mean?
Domus Line's D-Motion Dual Colour LED allows you to select Natural White or Warm White colour in one product.

For kitchen makers, cabinet makers and joiners, you'll no longer need to stock two light colour variants, so if you hold LED stock you'll have less funds tied up.
For homeowners, you can trial light colours in situ after installation and choose the one you prefer, or alter it any time to suit your mood and vibe.
Whether you're a designer, a maker or a homeowner, D-Motion puts the power in your hands!

PLUS FREECUT innovation means you can cut AT6 Pro D-Motion Dual Colour modules at any point rather than at predetermined gradations, meaning there are no unlit sections after installation.

24Vdc micro profile with symmetrical light projection
Suits recessed or surface installation
Recessed - snug fit in 6mm x 6mm groove, no track or diffuser required
Surface - high seal 3M adhesive backing, with plastic fastening saddle and screws supplied
Milky effect diffusing silicone coating
Very flexible with minimum radius just 25mm
IP44 rated - if strip is cut, it impacts this rating
End caps same size as profile so entire profile can be flush panel recessed into the groove
Power cord may exit axially or radially to installation surface
10W/m
156 + 156 SHE LEDs/m
Supplied with double 2000mm power cables and Micro24 male connector
Power supply not included; order separately

Please refer to the diagram on the image carousel for clarification regarding the direction in which Domus Line AT6 Pro LED strip bends

Available in lengths of 2m, 3m and 6m. 

Domus Line 24Vdc AT6 Strip Lighting - Super Flexible Cut Length & Attached Power

Super flexible LED strip lighting without using traditional aluminium profile or plastic diffuser! 
Slim 6mm x 6mm, 24Vdc - the innovative AT6 from Domus Line of Italy.
Designed in Italy to comply with Australian/NZ standards
Milky-effect diffusing silicone coating means no visible dots
Suits recessed or surface installation
Recessed - snug fit in 6mm x 6mm groove, no track or diffuser required
Surface - high seal 3M adhesive backing, with plastic fastening saddle and screws supplied

276 high performance LEDs per metre - 50 lumens/watt
Minimum radius of just 25mm
Available in 2m, 3m and 6m lengths
Customisable lengths - AT6 strip may be cut in 21.7mm increments
IP44 protection
Power cable at each end allowing excess offcut to be reused

Don't forget! Order LED Drivers separately.
Operates with existing DOMUS Line extension cables (DOM839, DOM840) and LED Drivers (DOM881, DOM882, DOM883)

Maximum continuous run length: 6m per any one strip.
Multiple lengths may be run from a distributor block providing driver capacity is sufficient.

Please refer to the diagram on the image carousel for clarification regarding the direction in which Domus Line AT6 LED strip bends.

Domus Line 24Vdc SE H4-24 Pro D-Motion Dual Colour Side Emission LED Strip

What does D-Motion Dual Colour mean?
Domus Line's D-Motion Dual Colour LED allows you to select Natural White or Warm White colour in one product.

For kitchen makers, cabinet makers and joiners, you'll no longer need to stock two light colour variants, so if you hold LED stock you'll have less funds tied up.
For homeowners, you can trial light colours in situ after installation and choose the one you prefer, or alter it any time to suit your mood and vibe.
Whether you're a designer, a maker or a homeowner, D-Motion puts the power in your hands!

PLUS FREECUT innovation means you can cut SE H4-24 Pro D-Motion Dual Colour modules at any point rather than at predetermined gradations, meaning there are no unlit sections after installation.

24Vdc micro profile with symmetrical light projection
Designed for flush recessed installation in a through-milling 4mm wide and 8mm deep
OR can be mounted for toe kick illumination with toekick mounting clips (DOM516)
OR integrate into Tynn aluminium profile (DOM630/DOM631)
Milky effect diffusing silicone coating
Very flexible with minimum radius just 15mm
IP44 rated - if strip is cut, it impacts this rating
Consistent profile dimension end to end for easy installation (no protruding endcaps)
Power cord may exit axially or radially to installation surface
10W/m
156 + 156 LEDs/m
Supplied with double 2000mm power cables and Micro24 male connector
Power supply not included; order separately

Please refer to the diagram on the image carousel for clarification regarding the direction in which Domus Line SE H4-24 Pro LED strip bends

Available in lengths of 2m, 3m and 6m. 

Domus Line 24Vdc Strip Lighting - Flexyled SE H4-24 Side Emitting High Emission

Flexyled SE-H4-24 is a flexible, side-emitting, high emission, no dotted effect 4mm LED strip ideal for recessed, profile and surface installation.
This contemporary option requires no aluminium profile or trim and can be press-fitted without glue or adhesives into curved milled grooves or rings (minimum radius 15mm), making it a superb choice for decorative lighting installations.
When recessed, Flexyled SE H4-24 presents an attractive, perfectly flush surface ideal for use in cabinets, drawers and cupboards, under shelves and in custom furniture.
Also able to be fitted with toekick clips, SE H4-24 is an excellent system for toekick lighting, with no pre-milling or prep required.
With a waterproof rating of IP44, SE H4-24 suits use in kitchens and utility rooms.

24Vdc
180 LEDs per metre
Minimum radius just 15mm
Divisible at 33.3mm increments
IP44 rated
Natural White or Warm White
1000mm length with single power cord
2000mm, 3000mm or 5000mm lengths with double power cords

Installation Options
Press fit (no glue/adhesive needed) into routed groove 4mm x 8mm OR
Surface mount with screws & clips OR
Integrate into aluminium profiles

Please refer to the diagram on the image carousel for clarification regarding the direction in which Domus Line SE H4 LED strip bends.

Domus Line 24Vdc UHE6B CSP D-Motion Dual Colour Ultra High Emission LED Strip

What does D-Motion Dual Colour mean?
Domus Line's D-Motion Dual Colour LED allows you to select Natural White or Warm White colour in one product.

For kitchen makers, cabinet makers and joiners, you'll no longer need to stock two light colour variants, so if you hold LED stock you'll have less funds tied up.
For homeowners, you can trial light colours in situ after installation and choose the one you prefer, or alter it any time to suit your mood and vibe.
Whether you're a designer, a maker or a homeowner, D-Motion puts the power in your hands!

24Vdc ultra high emission LEDs on 6mm flexible linear module with adhesive base
Designed for use with micro profiles with a removable diffuser
Dimmable
10W/m
304+304 CSP (Chip Scale Package) LEDs/m
Divisible every 26.3mm (8+8 LEDs)
Can be configured in custom-length modules in multiples of 26.3mm (8+8 LEDs, 0.26W) up to a maximum of 5000mm
Supplied with double 2000mm power cables and Micro24 male connector
Power supply not included; order separately

Available in lengths of 2m, 3m, 5m and 20m

Domus Line 24Vdc Strip Lighting - Flexyled HE6B Pro - High Emission

Flexyled HE6B is a high-emission, flexible pre-wired LED strip option that is just 6mm wide, with a very slim clip on the cable.
It is supplied with a high adherence 3M adhesive base so it may be surface mounted or integrated into profiles with a removable diffuser.
It is IP20 rated and designed with reinforced soldered power supply cable terminals to ensure good solidity.
It may be surface mounted via adhesive strip (included) OR integrated into a profile with a removable diffuser, leaving the adhesive on.

24Vdc
120 LEDs per metre
Divisible at 50mm / 6 LEDs
IP20 rated
Natural White or Warm White 
10m rolls
2m,3m and 5m pre-cut, pre-wired lengths with options wired at one end or at both ends (double wiring enables offcuts to be used, reducing waste)

Compatible with Nexus profile, Apex Dark profile (leave adhesive tape backing on or use sliding type of strip without backing) and any CH-suitable extrusion.

HE6B LED strip with a single power cord is being phased out as the double-tailed options offer more flexibility; offcuts can be reused helping to prevent waste.
Individual single-tailed models will be removed from the website as stock sells through.
If you require volume of a single-tailed option please check stock levels with us before specifying/ordering.

Domus Line 24Vdc SHE6B PW D-Motion Dual Colour Super High Emission LED Strip

What does D-Motion Dual Colour mean?
Domus Line's D-Motion Dual Colour LED allows you to select Natural White or Warm White colour in one product.

For kitchen makers, cabinet makers and joiners, you'll no longer need to stock two light colour variants, so if you hold LED stock you'll have less funds tied up.
For homeowners, you can trial light colours in situ after installation and choose the one you prefer, or alter it any time to suit your mood and vibe.
Whether you're a designer, a maker or a homeowner, D-Motion puts the power in your hands!

24Vdc super high emission LEDs on 6mm wide flexible PCB with adhesive base
Designed for use with micro profiles with a removable diffuser
A 3m 'sliding' option without adhesive base is also available for easy use sliding into profiles without a removable diffuser 
Dimmable

10W/m
168+168 LEDs/m
Divisible every 41.7mm (7+7 LEDs)
Can be configured in custom-length modules in multiples of 41.7mm (7+7 LEDs, 0.42W) up to a maximum of 5000mm
Supplied with double 2000mm power cables and Micro24 male connector
Power supply not included; order separately

Available in lengths of 2m, 3m, 5m and 10m. 
 

Domus Line 24Vdc Strip Lighting - Flexyled SHE6B Pro - High Emission

Flexyled SHE6B is a super high-emission, flexible pre-wired LED strip option that is just 6mm wide, with a very slim clip on the cable.
It is supplied with a high adherence 3M adhesive base so it may be surface mounted or integrated into profiles with a removable diffuser.
It is IP20 rated and designed with reinforced soldered power supply cable terminals to ensure good solidity.
It may be surface mounted via adhesive strip (included)OR integrated into a profile with a removable diffuser, leaving the adhesive on.

Additionally, there are 3m options in Warm White (DOM692) and Natural White (DOM693), with no adhesive backing at all, that are specifically designed for sliding into a profile.

24Vdc
180 LEDs per metre
Divisible at 33mm / 6 LEDs
IP20 rated
Natural White or Warm White 
2m, 3m and 5m pre-cut, pre-wired lengths with options wired at one end or at both ends (double wiring enables offcuts to be used, reducing waste)

Compatible with Nexus profile, Apex Dark profile (leave adhesive tape backing on or use sliding type of strip without backing) and any CH-suitable extrusion.

SHE6B LED strip with a single power cord is being phased out as the double-tailed options offer more flexibility; offcuts can be reused helping to prevent waste.
Individual single-tailed models will be removed from the website as stock sells through.
If you require volume of a single-tailed option please check stock levels with us before specifying/ordering.

Domus Line 24Vdc Strip Lighting - Flexyled HE (High Emission) CR

24Vdc LED strip from Domus Line is a highly innovative product in flexible linear LED strip lighting. It comprises straight line and 90° corner modules with a quick plug system; no soldering equipment required! Highly resistant double sided adhesive backing strip makes for fast and tool-less installation. It's ideal for both surface and embedded installation with cabinets and toekicks and with Domus Line aluminium lighting profiles.